Import custom weld

This feature allows the user to import a DXF file and to use it as a custom weld profile.

Top, Side, End and ISO specimen views

This feature allows the user to display the specimen with its weld overlay from the TOP, the SIDE, the END and the ISO view.

Heat Affected Zone

This feature allows the user to display the specimen with its weld overlay in TOP, SIDE, END and ISO views, showing the Heat Affected Zones (HAZ) vertically and along the weld profile.

Propose Setup

This feature allows an inspection supervisor to program basic rules that will be used by TOPAZ to propose a specific set-up to the user.

Once accepted by the user, TOPAZ will automatically prepare and program the settings and the layout.

The operator will then be prompted to position the probes on the scanner ruler.

Probe detection – Multiprobe

In conjunction with the TOPAZ splitter box, the optional software will detect the dialog information from the two connected phased array probes and will check probe traceability from calibration to acquisition.

Camera support

This feature allows the user to view the streamed video from the cameras on the TOPAZ screen, allowing immediate identification of any potential issues during data acquisition.

The software feature supports the upload of a custom overlay, facilitating the weld-scanner alignment.

Graticular overlays emulate laser lines.

Motorization control

This feature allows the user to control the motorized scanner directly from the TOPAZ Graphical User Interface (GUI).

Probe tracking

This feature allows the user to be sure that the probe used for the calibration is the same as the probe used for the data collection.